Torque

the_dare · Post by **the_dare** » Fri Dec 14, 2007 9:56 pm

lol just make sure you have lots of id otherwise you'll get turned down!

karate5662 · Post by **karate5662** » Sun Feb 17, 2008 1:18 am

just wondering but, what kind of models does the torque engine support by default?
I think one of our best bets for model format, as far as ease of use goes, is .3ds because it supports models as well as animations using bones.

Hockfire · Post by **Hockfire** » Sun Feb 17, 2008 9:21 am

JetChambers wrote:QUOTE (JetChambers @ Feb 17 2008, 01:18 AM) just wondering but, what kind of models does the torque engine support by default?
I think one of our best bets for model format, as far as ease of use goes, is .3ds because it supports models as well as animations using bones.

the_dare wrote:QUOTE (the_dare @ Nov 11 2007, 03:48 PM) torque uses .dts files which can be exported from milkshape!

This means that I (Using Wings3D) could convert .wings in .obj (in Wings3D) and then convert .obj in .dts (in MilkShape)

Same if you already have a .obj or a .3ds, but less complicated, as you just convert them to .dts in Milkshape. The point is that Torque (as far as I know) will only accept .dts.

There's a 30 day trial of Milkshape at www.download.com, but I wouldn't advise you to blow up the 30 days. Yet.

asheron2k · Post by **asheron2k** » Mon Feb 18, 2008 5:31 pm

The actual site for milkshape